Harley Davidson Exhaust Nut Torque
Repeat on the rear cylinder.
Harley davidson exhaust nut torque. Step 6 Raise the exhaust pipes back up and thread the head bolts and rear mounting bolts into position. Ad Fast Free Shipping on Orders Over 40. That is by the book page 2-178 for exhaust assembly.
097-109 mm Spark plug torque - 12-18 ft-lbs 16-24 Nm Oiling System. Motion Pro 08-0635 36mm Rear Axle Socket For Harley-Davidson. Route the oxygen sensor wiring back to their respective plugs and secure with wire ties as necessary.
Remove the original equipment OE exhaust system. Rear axle nut and left side axle hex are 36 mm. Accessing the rear axle nut on a H-D bagger was a pain to do until now introducing the new 36mm Axle Socket for Harley-Davidson.
Facilitates loosening and tightening of hard to reach rear axle nut on HD baggers. Posted by julian on Mar 26 2015. Remove heated oxygen sensors HO2S and retain for installation.
17Install the heat shield clamps into the heat shield. Additionally tighten the head pipe support bracket bolts as indicated in the exhaust manufacturers instructions. This table is based upon Grade 5 fasteners generally used Harley-Davidson motorcycles.
Tighten the collector heat shield clamp. Harleys head-bolt torque method harkens back to a time when torque specifications were less scientific. Bracket and install through the frame mounting bracket.